1. Preparation before commissioning

One swing brake wiring diagram and one set of swing brake equipment.

2. Check the wiring

Check the motor wiring and mains wiring according to the wiring diagram. Check whether the power wiring and other wiring of the whole equipment are correct. Power on and debug after confirmation!

The protective ground of the equipment must be reliably grounded, otherwise commissioning is not allowed;

3. Function debugging

1) This gate is a two-way normally closed swing gate. It is externally connected with incoming card swiping signal and outgoing card swiping signal.

2) When there is no card swiping signal, it will alarm when pedestrians enter from the incoming direction. Similarly, when there is no card swiping signal, it will alarm when pedestrians enter from the outgoing direction.

3) Pedestrian swiping the card for passage: when the pedestrian swipes the card, the direction indication changes to the green arrow, and the gate opening starts to delay. If the pedestrian passes within the set passage time, the gate will be closed, and the green arrow will change to red to prohibit. If the pedestrian still does not pass after the timeout, the gate will be closed, and the green arrow will change to red to prohibit.

4) If two people are too close to each other during pedestrian passage, they will be treated as one person within the specific time limit

5) The operating speed of swing switch is adjustable. See parameter setting for details

4. Power on operation

The intelligent swing gate is a normally closed swing gate. After power on, the gate will close automatically and open automatically after power failure.